Keshav Bhat

Hi,

Yes, I am using the 5034 DPO. By fresh install of windows do you mean on the computer I am interfacing with or on the scope itself?

I am controlling multiple equipment through tabview, so I would prefer to stick to LabView, or move over to Matlab.

Unfortunately, I won't be able to share the program directly here.

Thanks.

I had been using LabView 2021 64 bit version with the Tektronix 5034 scope via a GPIB cable and tektronix 7k drivers for all my experiments. I was able to manipulate the scope and read data from it without any issue.

I needed to run a code using the 32-bit version of LabView, so I installed the 2022 Q3 32-bit version of LabView. Ever since, I have been unable to read waveform data from the scope in either of the 2 versions for any of the LabView programs I have used/written. All I get is a block of noise that lasts the length of the time frame I have on the scope and varies from 0 to some positive value that depends on the total scale on the scope, (not the amplitude of the signal I am trying to capture).

I tried uninstalling and reinstalling LabView, and deleting re-downloading the drivers but it has made no difference.

Any suggestions on what I should try next would be greatly appreciated.