Forum User

Hello,

I would like to know how to control the device with the software. I basically wants to avoid pressing buttons on the device and would like to control it with the software if any present. Please let me know.

In the past we have had some issues running multiple current probes with our MSO scope. For the TBS2204B is there a limit on how many current probes we can run at once?
We currently have a TCP0020 and TCP0030A probe, what if we use 4 of these at once?

I would like to be able to setup a RS-485 bus decode for my oscilloscope. I see videos online for setting up the decode functionality for RS-232, but for my application I need to be able todo so for 485. I would like to know both the physical connection setup needed to hook up the oscilloscope to read properly, and the steps necessary to configure bus decode on the device.

My circuit pulses once every second. that is one pulse that is -0.000005 seconds long. one pulse only every second .... the rest of the time is nothing ... I need to capture a picture of this pulse. I have been using tektronix with all different models to teach. The "BRAND NEW" I just received is hiding the secret on how I can look at this single pulse.

Hello, I am looking to figure out the baudrate of a serial line using an MS054, but can't figure out how to set more than one limit on measurements (ex, I want to measure only the first rise and fall on a signal) and I can only set one limit (searching for requirements).

I'm having an issue with getting a SMU 2450 to connect to KickStart. I am connected via ethernet, which is visible on the PC, but for some reason, KickStart does not recognize the device. I am running Windows 10 with a KickStart CD (Version 1.1), so not sure if that's the issue. Please contact me about KickStart options if I can not longer use CD

What GPIB Commands are available for TBS2000?

I am experiencing issues while downloading firmware for an MSO44. Last week I received the government regulation message while downloading and the message is still showing up a week later. Tried multiple browsers and platforms, and all of them are giving him the same message. What can I do to change this?

Please reach out regarding this.
Thanks

Hello,

I am looking into a possible purchase of the AFG1062 dual-channel function generator. Is it possible to produce on Channel 2 an inverted copy of Channel 1, to make a differential sine-wave drive up to 60 MHz?

I'm trying to purchase a fuse for the DMM4050. Here is the Fuse Line # 159-0063-00 from the manual.
I wanted to make sure it is the correct one that should be purchased & if not, please tell me which is correct.
Please & Thank You