Afonso Teles

Hi,

Please find attached with this post TLACAL 5.6 and 5.7.

I hope this software is of use to you.

Hi Xiang,

Sounds like you need the Delay measurement, available under the "Time Measurements" tab.

It is unclear to me what delay you wish to specify, perhaps you could explain more about your waveforms and what you wish to measure?

Hi Birjit,

I understand you are not using SCPI commands. I do not believe it is possible to change the file name.

I suggested you use SCPI commands or TekScope Utility to do logging of over 10000 files as this is not possible to do automatically on the instrument.

Hi Birjit,

I do not believe it is possible to change the name to add another digit.

Instead, I would suggest using the programming interface, as defined in the programmer's manual, to customize your saved files with the SAVE:WAVEFORM command.

If you do not wish to get into the SCPI commands, you could also consider using TekScope Utility to achieve the same functionality through its data logging feature: https://forum.tek.com/viewtopic.php?t=140451

Hi Francisco,

Yes, one probe per channel is included with the TBS1000C, as mentioned on page 11 of the datasheet.

Hi Howard,

SCPI commands are case insensitive, as mentioned on page 15 of the programmer's manual.

the write_binary_values method does indeed automatically do the binary formatting, as mentioned in the pyvisa docs

I have included a python example of loading a waveform into ememory of an AFG31000. I hope it's of use to you.

Hi Mathias,

A formula for the record length required when using BUJ is not publicly available.
I will mention that one can change the minimum number of UI require by going into Select -> Preferences -> Jitter Decomp .

Perhaps if you could give us more insight into why you need to calculate the required record length, we would be able to help you?

Hi Mathias,

For many of the more of the more complex jitter measurements, the record length required is a function of the minimum number of pattern repeats. That is to say, if the minimum pattern repeat for the measurement is 100, then your required record length will be whatever it takes your waveform to reach that number of pattern repeats.
The error or warning icon should tell you how many patterns are found and how many are needed.

Hi Eric,
 

The ports on the MSO70kC are TekConnect ports.
 

TekConnect to BNC or SMA (both 50 ohms) adapters are available here: https://www.tek.com/en/datasheet/tekconnect(tm)-adapters

Hi Ryan,

The 2232 has a digital storage mode which should allow you to view these slow sweep speeds much easier.
This mode is described on page 3-8 of the operator's manual available on the TekWiki: https://w140.com/tekwiki/wiki/2232
The slow speed storage mode is likely of most interest to you.

I will also mention that it does appear your signal is "clipping", as in, it's going over the vertical scale. This can result in inaccurate measurements.
I would suggest reading the XYZ of scopes: https://www.tek.com/en/documents/primer/xyzs-oscilloscopes-primer