Tektronix Applications Expert

Hello,

I recommended using a 237-BAN-3A and 2600-TRIAX.

Hello,
Shipped with the P6616,(see in the manual link below), as standard accessories are added extension Gnd, and probe tip holder to keep them all together.

This setup to be mated with the 0.1 inches (or 2.54mm) apart 2x8 square pin header.
https://www.tek.com/en/manual/p6616-071283101

Hello

It is unlikely that the TBS1000 drivers will work with a TBS2000B. We do not have these drivers available for the TBS2000B series of scopes.

It is likely that service/repair is required.

To set up a repair RMA (model and serial number)
call 1-800-833-9200 opt 2.
Or send an email to rmarequest@tektronix.com
https://www.tek.com/en/services/repair/mytek_rma_request

Hello,
Please contact our service team at the contacts below.
The CSA7404 is on best effort depending the issues they maybe able to repair but they will not know until they see the unit.

To set up a repair RMA (model and serial number)
call 1-800-833-9200 opt 2.
Or send an email to rmarequest@tektronix.com
https://www.tek.com/en/services/repair/mytek_rma_request

Hello,

The DMM916 went out of support in 2001. We no longer provide support on this item and stopped production of most all the handheld DMM's about this time.

It could be a hardware issue and a repair is needed or an OS restore then reload the TekScope app could fix it.

Hello,

The internal AFG on the MDO3012 does not have the ability to produce a swept waveform, and the scope does not feature a dedicated bode plot tool. However, you have two options on how to generate a bode plot using the MDO3102.

The first is to set the AFG output to noise, feed it through the DUT, and into the RF input of the scope. This will show you amplitude response, but will not show phase.

The second option is to connect the AFG output to channel 1 and the DUT input, then the output of the DUT to channel 2. Use the built in measurements to find amplitude and phase, then use a script to sweep the AFG, record the measurements, and then plot the data.

Power Analysis is a purchasable option that your scope might not have installed. You can check this in the About page under the Help header. The software would show up in the Installed Options table if it is on the scope.

Hello,
The Recovery Media must be the Tektronix version that matches the Model serial number and hardware in the scope.

Also it could just be a bad disk, or the scope is not working well enough to even do the OS restore in which case a repair will be needed.